Uni-bond E-F291-2 Guide D'utilisation

Controls:
Flash pattern selected
to lit up on the control
box indicator only
(light stays off)
Installation:
To connect the light unit to the control box
1. Turn anti-clockwise to loosen terminals
2. Insert all 11 wires into the slots on
the control box per colour coded
3. Turn clockwise to tighten terminals
Pattern Selection (8 Flash Patterns):
NO.
1 Left & Right Alternating Quad Flash (2 sequences)
2 Left & Right Alternating Quad Flash, Full Unit Quad Flash (3 sequences)
3 Full Unit Quad Flash (1 sequence)
4 Left & Right Alternating Single Flash (2 sequences)
5 Centre Quad Flash, Left & Right Quad Flash (2 sequences)
6 Left to Right Sequential Flash to fill the lights (6 sequences)
7 Right to Left Sequential Flash to fill the light (6 sequences)
8 Centre Single Flash, Centre to Left & Right Sequential Flash to fill up the light (4 sequences)
For more information, visit our website at: www.unibondlighting.com
USER MANUAL
E-F291-2 Control Box
For Use with E-2940A/AC, E-2980A/AC & E-2990A/AC
Both the light &
the control box
indicator are lit up
OFF
DASH LIGHT
ONLY BAR
CONTROL BOX INDICATOR
Flash Patterns
Quick Selection
Right to Left Sequential Flash
(on both the light & the control box indicator)
Left to Right Sequential Flash
(on both the light & the control box indicator)
FLASH
MODE
_
+
_
+
POWER
1. Turn anti-clockwise to loosen terminals
2. Insert positive wire to +
3. Insert ground wire to -
4. Turn clockwise to tighten terminals
Push once to select
the next flash pattern
FUSE
10A/32VDC
(included)
SAE
SAE