Ecco EC2028-WC Instructions D'installation page 3

Installation, Wiring and Function
Installation:
Camera Model EC2028-WC
Important! Mount the camera at a location that provides the best view of the area immediately behind the vehicle.
Generally, mounting locations toward the top of the vehicle provide the best field of view. Lower mounting locations
reduce the field of view and increase the likelihood of damage from road spray.
1. Find an appropriate location for installation.
2. Drill holes according to the size of U-bracket and fix the U-bracket.
3. Drill a 3/4" (19mm) hole next to U-bracket.
4. Install the camera on U-bracket.
5. Connect the camera tail with the extension cable from inside the vehicle.
6. Loosen the hex head screws and adjust the camera's position to get the best view angle in the monitor.
Wiring:
Important! Waterproof all connections whether inside or outside the vehicle by using sealant and wrapping with
insulation tape. Wrap tape tightly, overlapping by one-half widths so there are no gaps.
Two Wires
DC12V (RED)
GND (BLACK)
Pairing:
When monitor is in the PAIR function and 50 sec countdown is in progress, press and hold for 5 seconds PAIR button
on the back of camera for successful pairing process.
Picture depicted is for reference only.
RF socket
Pair Button
Page 3 of 6