White-Rodgers 5C02 Instructions D'installation

WHITE-RODGERS
Operator: Save these instructions for future use!
FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY BEFORE
INSTALLING OR OPERATING THIS CONTROL COULD CAUSE PERSONAL
INJURY AND/OR PROPERTY DAMAGE.
The 5C22 warm air fan controls are designed to control
fan operation in a forced air heating system. They will start
the fan circulating warm air when the plenum temperature
rises and stop the fan when the plenum temperature falls
below a predetermined setting, to prevent the circulation
of cold air.
The 5C02 warm air limit controls are designed to act as
a safety switch which automatically shuts off the burner
if the furnace temperature reaches a dangerously high
point. These limit controls have special contacts which
are suitable for use on low voltage and millivolt (thermo-
CAUTION
!
To prevent electrical shock and/or equipment
damage, disconnect electric power to Furnace at
main fuse or circuit breaker box, until installation
is complete.
ELECTRICAL DATA
Electrical Rating:
5C22 – 8 FLA, 120V, 6 FLA, 240V 60 Hz.
5C02 – 10 FLA, 120V, 6 FLA, 240V 60 Hz.
SWITCH ACTION:
5C22 FAN – Close On Rise
5C02 LIMIT – Open On Rise
If furnace manufacturer has made provision for, or recom-
mendations for location of this control, then follow those
instructions. If not, the following suggestions should be
observed for general purpose installation in the plenum.
The control should be positioned so that it will be located
WHITE-RODGERS DIVISION
EMERSON ELECTRIC CO.
9797 REAVIS RD., ST. LOUIS, MO. 63123
(314) 577-1300, Fax (314) 577-1517
9999 HWY. 48, MARKHAM, ONT. L3P 3J3
(905) 475-4653, FAX (905) 475-4625
R
5C02 / 5C22
Warm Air Fan / Limit Controls
INSTALLATION INSTRUCTIONS
couple generator type) circuits as well as line voltage
equipment such as gas valves, oil burner motors, etc.
Both fan and limit controls can be combined in one
enclosure for operating both fan and limit.
!
Do not use on circuits exceeding specified volt-
ages. Higher voltages will damage control and
could cause shock or fire hazard.
THERMAL DATA
Range: 5C22 FAN
5C02 LIMIT – 150° to 250°F (66° to 121°C)
Diff: 5C22 FAN
5C02 LIMIT – Fixed 25°F (14°C)
ACCESSORIES:
Single Control case W.R. Part No. F12-1745
Dual Control case W.R. Part No. F12-1746
in the area which is subjected to the most rapid tempera-
ture changes. Avoid locations where there may be dead
air spots or stratification affecting free air circulation.
Corners, sharp turns, baffles or other obstructions usually
cause these conditions (Fig. 1).
Printed in U.S.A.
DESCRIPTION
PRECAUTIONS
WARNING
SPECIFICATIONS
– 70° TO 125°F (21° to 52°C)
– Adj. 25° to 50°F (14° to 28°C)
INSTALLATION
PART NO. 37-5449A
9506