Grundig DTR 6000 X Mode D'emploi page 34

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

SETTINGS
If you wish to exit the menu prematurely,
7
press » «, » «, » « or » « or by turning
the Volume Knob to select the push button
»CANCEL« and press »OK« to confirm.
16
Press »OK« to end the setting.
Setting DAB stations
Automatic station search
If you first switch on the device in DAB mode, the
automatic station search starts.
During the search, the first line shows the num-
ber of stations found, and the second shows the
search scale.
After the end of the search, an alphanumeric ar-
rangement of stations appears. If no stations are
found, the DAB menu appears in the display.
1
To enter DAB mode, either press
INFO« button --> select "Main menu" --> DAB
or press »MODE« button then turn the Volume
knob clockwise or anticlockwise to scroll left or
right through the mode list until DAB Radio is
highlighted and press »OK«.
Note:
In the »DAB Radio« – »Full scan« menu, you
7
can restart a new "Automatic station search".
This may be necessary when the location of
the device is changed.
Sorting channels
You can sort the station list stored during the sta-
tion search in three different ways.
– »Alphanumeric«: all stations are sorted alpha-
numerically (default setting).
– »Ensemble«: all stations are sorted by ensemble.
– »Valid«: active stations are listed first, stations
that are not active are shown with a question
mark.
1
Press »MENU« to open the DAB menu.
2
Select the option »Station order« by pressing
» « or » « or by turning the Volume Knob
and confirm by pressing »OK«.
3
Select your settings by pressing » « or » «
or by turning the Volume Knob and confirm by
pressing »OK«.
34
ENGLISH
---------------------------------------------------------------------------------------------------------------------------------------
»Menu/
Setting FM stations
Setting the search mode
There are two different automatic scan setting
modes.
1
To enter FM mode, either press »Menu« but-
ton --> select "Main menu" --> FM or press
»MODE« button then turn the Volume knob
clockwise or anticlockwise to scroll left or right
through the mode list until FM Radio is high-
lighted and press »OK«.
2
Press »MENU« to open the »FM« menu.
3
Select the option »Scan setting« by pressing
» « or » « or by turning the Volume Knob
and confirm by pressing »OK«.
– Display: »Strong stations only?«.
4
Select your setting (»YES« or »NO«) using
» « or » « or by turning the Volume Knob and
confirm by pressing »OK«.
5
Press »MENU« to end the setting.
Automatic station search
1
Press and hold » « or » « or press the Volume
Knob. When you release the button, the auto-
matic search stops at the next station.
Note:
Press Menu button and select the option
7
»ATS« and confirm by pressing »OK«. Se-
lect the option »YES« and confirm by press-
ing »OK«. The automatic station search
starts, searches and stores the radio stations.
Tuning stations manually
1
Move the frequency forward in brief steps by
repeatedly pressing » « or » «.
– The frequency goes up or down in 50 kHz
steps.

Publicité

Table des Matières
loading

Table des Matières