Cleaning Modes; Different Methods Of Cleaning - RND 605-00033 Mode D'emploi

Cleaning Modes

Degas Mode: Degas mode will start intermittent operation of the
ultrasonic power. This ensures rapid removal of air from liquids.
This can be started via the degas button. This button will also stop
the cleaning prior to timed ending if needed.
Delicate Mode: The ultrasonic cleaner delivers half power to pro-
vide a less aggressive clean for delicate items. To start the delicate
mode press the delicate button. This button will also stop the
cleaning prior to the timed ending if needed.
Full Mode: The ultrasonic cleaner delivers its maximum ultrasonic
power to provide an aggressive clean for heavily soiled items. The
full button will start Full mode on your ultrasonic tank. This button
will also stop the cleaning prior to the timed ending if needed.
Different Methods of Cleaning
General Cleaning: For lightly soiled objects we suggest only using
warm water. This should be
paired with a temperature around 40°C .
Enhanced Cleaning: If the objects in question need a deeper clean
then we advise the use of
an ultrasonic cleaning solution mixed weakly and heated to the
mid range of the fluids operating temperature. Again a warm
temperature between 40-60°C will help you achieved your desired
results.
Extensive Cleaning: For the removal of tarnish, fuel and hard
carbon deposits, and rust from non-plated metals, etc, we recom-
mend a pre-soaking in the ultrasonic bath of detergent/solvent
mixed to its strongest concentration ratio to soften unwanted
deposits whilst heated to the high end of the fluids operating tem-
perature range. These steps coupled with the Full mode will ensure
the best cleaning possible.
9