Babyauto Irbag Top Plus Notice D'instruction page 40

All manuals and user guides at all-guides.com
5. Tighten the lap belt and diagonal shoulder belt, then
place the red safety clip
belt tongue as near to the vehicle anchor point as
possible without touching it! (4.7, 6.1, 6,2 y 6.3).
Make sure the vehicle's safety belt is not twisted,
also check that the seat cover does not impede the
movement of the vehicle's safety belt or prevent
the installation of the seat in any way. To release
your child unbuckle the vehicle safety belt as
described in the instructions.
Ensure that the belt has no slack.
5. INSTALLING CHILD SEAT. GROUP 2.
WARNING
Installing the child seat forward facing can only be maid
if the child is more than 15 kg.
1. For Group 2 installing from the back of the seat,
unhook the
and detach the harness from the
of harness, pull the loose strap towards the front of
the seat to detach completely from the seat (5.1, 5.2
y 5.3).
2. Fit this child seat into the vehicle´s seat, making sure
it is firmly pressed against the vehicle seat backrest
(5.4).
3. Place the child in the child car safety seat (5.5).
4. Insert the seat belt through the
anchor point (5.6, 5.7 y 5.8).
5. Fasten the seat belt into the vehicle´s buckle until
it "clicks", making sure the child seat is properly
installed (5.6).
Group 0/1/2
IMPORTANT
K harness protector connector tapes
N on the diagonal shoulder
Only suitable for Group 2, approx.
4 to 6 years of age (15-25 Kg.)
M
I
www.babyauto.com
metal connector
guide behind the
EN
33 33