LEGRAND Plexo 55 Mode D'emploi page 10

This product can store 16 different On codes and 16 different Off codes per output. It is not, however, possible to combine operating modes.
Timer, Switch and Pushbutton modes will be identical for all the codes stored on one output.
Important :
When pushbutton n is pressed for more than 2 seconds the On/Off indicator flashes to indicate the change to teach mode.
If the indicator flashes very quickly 3 times after pushbutton n is released, this indicates that the receiver cannot be taught any more codes.
The user has two options : either to abandon teaching another transmitter, or to clear all the codes and start teaching 16 new codes.
Do not exceed a period of 30 seconds between two presses on one key, otherwise the receiver will automatically exit teach mode.
Programming symbols
Press the button shown
BPn
Press for more than 2 seconds
BPn
> 2 s
Release the button
BPn
Selecting the operating mode
>
Timer mode :
2 s
Switch mode :
Pushbutton mode :
The mode can be changed by pressing pushbutton BPn repeatedly.
BPn
> 2 s
Teaching Switch mode
Important :
It is possible to control a receiver via 2 different keys on one transmitter (use
as a switch, A) or via a single key on one transmitter (use as remote switch,
B). However, use as a switch is preferable if the environment is subject to
interference.
Selecting the mode
BPn
> 2 s
Teaching the On code
M/A
Teaching a single Off code
OK
OK
M/A
<
8 mn 30 s
OK
Tempo
M/A BPn M/A
Inter
Poussoir
OK
M/A BPn M/A
Poussoir
OK
M/A
M/A
M/A M/A
The indicator shown is off
M/A
The indicator shown flashes slowly
M/A
The indicator shown flashes quickly
M/A
The indicator shown is on
M/A
Tempo
BPn BPn
Inter
Poussoir
BPn
A
OK OK
Tempo
BPn
Inter
Teaching the Off code
OK
M/A
M/A
10
Tempo
BPn BPn
Inter
Poussoir
BPn
B
Tempo
M/A
Inter
Poussoir
M/A M/A
If a single Off code is
taught to a number of
OK
receivers, it can be used
to perform a general
M/A
switch-off.
M/A