Maintenance And Care; Troubleshooting - Schumacher Electric SCF-8020A Guide D'utilisation

13. MAINTENANCE AND CARE

A minimal amount of care can keep your
battery charger working properly for years.
• Clean the clamps each time you are
finished charging. Wipe off any battery
fluid that may have come in contact with
the clamps to prevent corrosion.
• Occasionally cleaning the case of the
charger with a soft cloth will keep the
finish shiny and help prevent corrosion.

14. TROUBLESHOOTING

PROBLEM
The battery is connected
and the charger is on, but
isn't charging.
Indicator lights are lit in
an erratic manner, not
explained in this manual.
The Digital Display
always flashes before
the battery is completely
charged.
The green CHARGED
LED lights a few minutes
after connecting to the
battery.
All manuals and user guides at all-guides.com
POSSIBLE CAUSE
The charger is in tester mode,
not charger mode.
You might have accidentally
activated a special diagnostic
mode.
The incorrect battery type may
have been selected. This will
happen if the battery did not reach
full charge within 24 hours. May
be due to a very large battery
or a bank of batteries requiring
more power than the charger
can deliver within 24 hours. The
battery may also be faulty.
The battery may be fully charged
or recently charged, leaving the
battery voltage high enough to
appear to be fully charged.
The incorrect battery type may
have been selected.
• 11 •
• Coil the input and output cords neatly
when storing the charger. This will help
prevent accidental damage to the cords
and charger.
• Store the charger unplugged from the AC
power outlet, in an upright position.
• Store inside, in a cool, dry place. Do not
store the clamps clipped together, clipped
to the handle, on or around metal, or
clipped to the cables.
SOLUTION
Press the BATTERY SIZE
button to activate charging and
select a charge rate.
Make sure nothing is touching
the control panel, then unplug
the charger and plug it in again.
Reset the charger by briefly
unplugging it or briefly
disconnecting the negative
battery clamp. Select the
desired rate (SMALL or LARGE
BATTERY) and BATTERY
TYPE again, if necessary.
If the battery is in a vehicle,
turn the headlights on for a few
minutes, to reduce the battery
voltage; then try charging again.
Reset the charger, by briefly
unplugging it or briefly
disconnecting the negative
battery clamp. Select the
desired rate (SMALL or LARGE
BATTERY) and battery type
again, if necessary.