Maintenance; Spare Parts; Troubleshooting; The Appliance Does Not Start - Santos 11 Mode D'emploi

MAINTENANCE

Before any servicing of the appliance, it is essential to unplug the appliance from the
mains supply (7).
This machine requires no particular maintenance because the bearings are lubricated for
life.
If servicing is necessary to replace any parts such as the electrical components or any
others, refer to the list of components (see the exploded view at the end of the manual).

Spare parts

!
For all spare part orders (see references in the exploded view at the end of the manual),
state:
 the type,
 the machine serial number and
 the electrical specifications (16)
recorded under the machine.

TROUBLESHOOTING

Identifying the cause of appliance stoppage precisely.

The appliance does not start:

 Check: the mains supply, the condition of the power cord (7).
The appliance stops due to motor overheating: (the motor unit is hot)
The motor is protected by a built-in thermal cutout. In the event of overheating, the motor
stops.
 Set the On / Off switch (6) to 0 position, disconnect the plug (7).
 Wait until the motor cools down (20 to 45 minutes), reconnect the plug (7) then press
the On / Off switch (6) (position 1).
If the problem persists, switch off the power supply to the appliance (unplug the cord from
the mains socket (7)) and call in the maintenance service or contact a SANTOS-approved
dealer.

The appliance stops further to an overload:

If the motor stalls (due to excessive pressing), it can heat very quickly and stops by
overload protection.
408007-010-011-152-252 en ma 2010.12
IMPORTANT: Use of spare parts other than certified original SANTOS
parts is prohibited
7/13