HUUM CLIFF Mode D'emploi page 6

NB! It is forbidden to use a non-heat-resistant cable with PVC isolation
as the power cable. The joint box must be waterproof and it must be
located up to 50 cm from the floor.
CLIFF 3,5 kW
230V 1~
• Open the cover of the heater's electrical box.
• Attach the power cable on the terminal block according to the
circuit diagram.
• Close the cover.
• Fix the cable on the output with a cable strap.
Fittingthestones
Upon stacking the stones, one should monitor that the heating
elements are not bent and that there is a sufficient air circulation
around the heater elements.
• The stones must be washed clean before laying.
• When the stones have been stacked too close to each other, the
heating elements may overheat (= shorter useful life) and slow the
heating of the sauna.
• Stones with a diameter of 3–6 cm are suitable for the heater.
• The stones on the external surface of the heater must fully cover
the heating elements. The heating elements must not be visible.
• Using ceramic stones in the CLIFF heater is allowed upon the
user's responsibility.
ATTENTION! Too sparsely filled stone container causes fire hazard!
6
CLIFF 6 kW
CLIFF 9 kW
CLIFF 10,5 kW
400V 3~
230V 1~