Télécharger Imprimer la page
Rockwell Automation Allen-Bradley 140G-M-F Serie Instructions Pour L'installation
Rockwell Automation Allen-Bradley 140G-M-F Serie Instructions Pour L'installation

Rockwell Automation Allen-Bradley 140G-M-F Serie Instructions Pour L'installation

Publicité

Liens rapides

140G-M-F_; 140G-N-F_
Installation instruction for Flex Cable Operator for 140G-M, 140G-N
Istruzioni di installazione
Installationsanleitung
Instructions pour l'installation
Instrucciones de instalación
Installation - Installazione - Instalación
Instalação -
WARNING:
To prevent electrical shock, disconnect from power source before
installing or servicing. Install in suitable enclosure. Keep free from contaminants.
(Follow NFPA70E requirements).
AVVER TENZA: Per prevenire infortuni, togliere tensione prima dell'installazione o
manutenzione. Installare in custodia idonea. Tenere lontano da contaminanti.
(Seguire i requisiti NFPA70E).
WARNUNG:
Vor Installations- oder Servicearbeiten Stromversor gung zur
Vermeidung von elektrischen Unfällen trennen. Die Geräte müssen in einem
passenden Gehäuse eingebaut und gegen Verschmutzung geschützt werden. (Befolgen
Sie die Anforderungen nach NFPA70E).
AVERTISSEMENT:
Avant le montage et la mise en service, couper l'alimentation
secteur pour éviter toute déchar ge. Prévoir une mise en coffret ou armoire appropriée.
Protéger le produit contre les environnements agressifs. (Vous devez respecter la
norme NFPA70E).
ADVERTENCIA: Desconéctese de la corriente eléctrica, antes de la instalación o
del servicio, a fin de impedir sacudidas eléctricas. Instálelo en una caja apropiada.
Manténgalo libre de contaminantes. (Cumpla con los requisitos NFPA70E).
ATENÇÃO: Para evitar choques, desconectar da corrente elétrica antes de fazer a
instalação ou a manutenção. Instalar em caixa apropriada. Manter livre de
contaminantes. (Cumpra as exigências da norma NFPA70E).
PN-406803
DIR 10001744089 (Version 02)
-
1/4-20 x .50 in
1/4-20 x .50 in
Bul. 140G/140MG
CLACK
140G-N Only
140G-N Only

Publicité

loading

Sommaire des Matières pour Rockwell Automation Allen-Bradley 140G-M-F Serie

  • Page 1 Bul. 140G/140MG 140G-M-F_; 140G-N-F_ Installation instruction for Flex Cable Operator for 140G-M, 140G-N Istruzioni di installazione Installationsanleitung Instructions pour l’installation Instrucciones de instalación Installation - Installazione - Instalación Instalação - WARNING: To prevent electrical shock, disconnect from power source before installing or servicing.
  • Page 2 Required xx lb-in xx Nm xx lb-in xx Nm 140G-M Shown 5.0” (127 mm) (4) - ø 0.218” ((4) - ø 5.5 mm) 13.5” (342.9 mm) U > 0V > 1.0" (25 mm) 50 - 60 lb-in (5.6 - 6.8 Nm) 3/8"...
  • Page 3 140G-M 140G-N Supplied with circuit breaker 140G-M 22 lb-in (2.5 Nm) 17 lb-in (2 Nm) PN-406803 DIR 10001744089 (Version 02)
  • Page 4 140G-M 140G-N 140G-M1, -P1 or -S1 140G-P2 140G-M 140G-N 7/16" 7/16" (11 mm) (11 mm) 30 - 40 lb-in 30 - 40 lb-in (3.5 - 4.5 Nm) (3.5 - 4.5 Nm) PN-406803 DIR 10001744089 (Version 02)
  • Page 5 140G-M 140G-N 10 - 15 lb-in 10 - 15 lb-in (1.2 - 1.7 Nm) (1.2 - 1.7 Nm) 140G-M Shown 3/8" 50 - 60 lb-in (5.6 - 6.8 Nm) PN-406803 DIR 10001744089 (Version 02)
  • Page 6 1 - Trip Breaker CLACK 2 - Reset Breaker See figure A Vedi figura A Siehe Abb. A Voir figure A Véase figura A CLACK 3 - Breaker On See figure B Vedi figura B Siehe Abb. B Voir figure B Véase figura B CLACK 4 - Breaker Off...
  • Page 7 100 lb-in (11.3 Nm) 100 lb-in (11.3 Nm) 15/16" 15/16" (24 mm) (24 mm) RESET PN-406803 DIR 10001744089 (Version 02)
  • Page 8 Rockwell Automation maintains current product environmental information on its website at http://www.rockwellautomation.com/rockwellautomation/about-us/sustainability-ethics/product-environmental-compliance.page. Allen-Bradley, Rockwell Software, and Rockwell Automation are trademarks of Rockwell Automation, Inc. Trademarks not belonging to Rockwell Automation are property of their respective companies. *PN-406803* PN-406803 DIR 10001744089 (Version 02) Publication 140G-IN135C-MU-P - January 2017 Copyright ©...

Ce manuel est également adapté pour:

Allen-bradley 140g-n-f serie