General Electric PFDS450 Manuel D'utilisation Et D'installation page 30

EXHAUSTING THE DRYER (cont.)
SIDE VENTING (cont.)
ADDING ELBOW AND DUCT FOR EXHAUST TO
LEFT OR RIGHT SIDE OF CABINET (cont.)
• Apply duct tape as
shown on the joint
between the dryer
internal duct and the
elbow, and also the
joint between
elbow and the side
duct.
CAUTION:
only inside the dryer. Internal duct joints must be
secured with tape, otherwise they may separate
and cause a safety
ADDING COVER PLATE TO REAR OF CABINET
(SIDE EXHAUST)
Plate
(Kit WE1M454)
Connect standard metal elbows and ducts to
complete the exhaust system. Cover back opening
with a plate (Kit WE1M454) available from your
local service provider. Place dryer in final location.
WARNING –
BACK OPENING WITHOUT THE PLATE.
WE1M454)
Installation Instructions
Duct tape
the
Use 4" rigid metal ducting
hazard.
NEVER LEAVE THE
(Kit
BOTTOM VENTING:
Dryer Exhaust to the bottom of cabinet for
Gas and Electric models.
WARNING –
THIS EXHAUST INSTALLATION, BE SURE TO
DISCONNECT THE DRYER FROM ITS ELECTRICAL
SUPPLY. PROTECT YOUR HANDS AND ARMS
FROM SHARP EDGES WHEN WORKING INSIDE
THE CABINET. BE SURE TO WEAR GLOVES.
Remove
screw
and save
Remove the screw inside the dryer exhaust duct
and save. Pull the duct out of the dryer. Detach and
remove the bottom knockout.
Cut the duct as shown and keep portion A.
30
BEFORE PERFORMING
Bottom
Remove desired
knockout (one only)
Fixing hole
A
13 "
1 4