Know Your Charger; Operation - HENX H36KC400 Mode D'emploi

English
Charger Weight
Allowable charge
temperature range

6. Know your charger

H36KC400: See Fig. A
H36MC100 (XVE129-4200300): See Fig. B
LED indicators
Indicate the charging status.
Mounting slot
Guides the battery pack when it is installed
on the charger.

7. Operation

NOTE: Lithium-ion battery packs are
shipped partially charged. Fully charge the
battery pack before first use.
H36KC400
Connect the charger to the power
7.1
supply by aligning the raised ribs of the
battery pack with the mounting slots on
the charge and sliding the into place
(See Fig. C).
Plug charger into appropriate electrical
7.2
outlet.
The charger will evaluate the condition
7.3
of the battery pack and begin charging.
The power indicator on the battery pack
will flash in sequence of red and green,
depending on what the charger
evaluates.
NOTE: When the battery pack is charging,
the green led on the charger will flash. When
the battery pack is fully charged, the green
led will stop flashing and remain green and
the power indicator on the battery pack will
go out. The fan in the charger continuously
works to cool the battery pack.
Wait until the cooling fan stops, remove
7.4
the battery pack from the charger and
disconnect the charger from the power
supply.
H36MC100 (XVE129-4200300)
Connect the charger to the power
7.1
supply by aligning the raised ribs of the
battery pack with the mounting slots on
8
3.97 lb. (1.80 kg)
32°F-104°F (0°C-40°c)
7.2
7.3
NOTE: When the battery pack is charging,
the green led on the charger will flash. When
the battery pack is fully charged, the green
led will stop flashing and remain green and
the power indicator on the battery pack will
go out. The fan in the charger continuously
works to cool the battery pack.
7.4
Please note:
• The battery pack will fully charge if left
• After battery pack is charged, remove
• The charger may warm during charging.
• Charge in a well-ventilated area avoiding
Charging a hot battery pack
Continuous use of the charger may cause
battery packs to become hot. Allow at least
30 minutes for the hot battery pack to cool
down before attempting to charge.
If the charger does not charge or if any
problems are detected, contact Customer
Service for support.
the charger and sliding the into place
(See Fig. D).
Plug charger into appropriate electrical
outlet.
The charger will evaluate the condition
of the battery pack and begin charging.
The power indicator on the battery pack
will flash in sequence of red and green,
depending on what the charger
evaluates.
Remove the battery pack from the
charger and disconnect the charger
from the power supply.
on the charger, but it will not overcharge.
and DO NOT leave on charger for an
extended period of time.
This is part of the normal operation of
the charger.
extreme heat and cold. Charger works
best at normal room temperature.