Getting Started - WatchGuard Technologies XTM 2050 Guide De Démarrage Rapide

Getting Started

1
Connect your WatchGuard XTM 2050 and Power it On
• M ake sure your computer is configured to use DHCP. When you connect it to the
XTM 2050, make sure it gets an IP address on the 10.0.1.0/24 network.
2
Run the Web Setup Wizard
• O pen a web browser and type https://10.0.1.1:8080 to start the Web Setup Wizard.
NOTE: Because the XTM 2050 uses a self-signed certificate, you may see a certificate warning in your browser.
It is safe to ignore the warning (Internet Explorer) or to add a certificate exception (Mozilla Firefox).
• L og in with the user name admin and the passphrase readwrite.
• F ollow the instructions on the screen and complete the Wizard.
NOTE: Your WatchGuard XTM 2050 now has a basic configuration that allows outbound TCP, UDP, and ping
traffic, and blocks all unrequested traffic from the external network.
• L og in to the Fireware XTM Web UI using the user name admin and the configuration
passphrase you set in the Wizard.
0
1
Internet
green
Router