How To Prepare The Record Player For Operation; Belt And Turntable; Turntable Mat; Spindle Adapter - TechniSat TechniPlayer LP 200 Mode D'emploi

How to prepare the record player
for operation

Belt and turntable

The record player is delivered with the drive belt already
fitted around the turntable flange. The belt is provided
with a red tape so that it can be pulled over the drive
motor pulley.
Place the turntable on the turntable spindle. Rotate
the turntable until the cut-out is positioned over the
motor pulley (at about the 8 o'clock position). See
illustration below.
Using the red tape, pull the drive belt over the motor
drive pulley and position it in the centre of the pulley.
Then remove the red tape.

How to prepare the record player for operation

Turntable mat

Now place the turntable mat on the turntable.

Spindle adapter

The spindle adapter is required, for example, for singles
without their own plastic spindle adapter. When the
spindle adapter is not in use, you can store it in the
designated area.

Tone arm

The tone arm 9 is secured for transport using a clip.
Remove this clip before operating the unit for the first
time. To transport the unit later, secure the tone arm
again using this clip to prevent damage from vibrations.
11