Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Source language: German
Explication of warning symbols
Safety instructions
Correct use
Unpacking
Product information
Installing the cleaning tube to disperser
Accessories
Technical data
DANGER
WARNING
CAUTION
NOTICE
• Read the operating instructions in full before starting up and follow the safety
instructions.
• Keep the operating instructions in a place where they can be accessed by everyone.
• Ensure that only trained staff work with the cleaning tube.
• Follow the safety instructions, guidelines, occupational health, safety and accident preven-
tion regulations.
• Set up the tube holder on an even, stable, clean, non-slip, dry and fireproof surface.
• Note the operating instructions of the disperser.
NOTICE
• Do not process any flammable or combustible materials with the cleaning tubes.
• Only process media that will not react dangerously to the extra energy produced through
processing with the tubes. This also applies to any extra energy produced in other ways,
e.g. through light irradiation.
• A cleaning/dispersing time of a few minutes is usually sufficient. Long processing time will
increase the temperature of the cleaning liquid or the medium.
• The tubes are not sealed. The filled tubes are not allowed to lay down!
WARNING
- splashing and evaporation of liquids
- body parts, hair, clothing and jewellery getting caught.
• Make sure that the stator has always minimum 10mm distance to the tube bottom (see Fig. 4).
• The liquid in the tube can get very hot after a short operation. Handle the tube with your
personal protective equipment.
Explication of warning symbols
Indicates an (extreme) hazardous situation, which, if not avoided, will
result in death, serious injury.
Indicates a hazardous situation, which, if not avoided, can result in
death, serious injury.
Indicates a potentially hazardous situation, which, if not avoided, can
result in injury.
Indicates practices which, if not avoided, can result in equipment damage.
Safety instructions
Never run dispersion tools without enough cleaning liquid or medium
in the tubes, as the gasket and bearings will be destroyed if the tools
are not cooled by the medium.
Wear your personal protective equipment in accordance with the haz-
ard category of the media to be processed. Otherwise there is a risk
from:
Content
EN
Page
6
6
7
7
7
7
7
7
6
Publicité
Table des Matières
