UDE AX-459 Mode D'emploi page 35

AX-459
How to start up the unit
INSTALLATION:
Install the optional accessories (if applicable). See graphic.
Change the sensitivity of the auxiliary input, if applicable. See graphic.
The unit should be connected as per the connection diagram, according to specific
requirements. Special care should be taken to comply with any applicable safety standards.
Note:
ADJUSTMENTS:
Start up the unit and make any adjustments you require:
- Impedance
- Volume microphone
- Volume auxiliary
- Treble
- Bass
- Programming (1 to 8)
- Operating mode (standard or programmed) selection
The unit is now ready to operate
FACTORY SETTINGS:
- Mode 1 operation (standard).
- Access code: 1, 2, 3.
- Impedance: 4
- Auxiliary input sensitivity: 770 mV.
- Input On (selected): microphone (E1).
- MODE 1 (standard)
Microphone input (E1)
- Volume: 7.0
- Treble: 0
- Bass: 0
Auxiliary input (E2)
- Volume: 7.0
- Treble: 0
- Bass: 0
- MODE 2 (programmed). -
Microphone input (E1)
- Volume: 7.0
- Treble: 0
- Bass: 0
Auxiliary input (E2)
- Volume: 7.0
- Treble: 0
- Bass: 0
We recommend you set the volume to 0 for programmes that are not used.
Do not block the front and rear air vents in order to make sure the unit will work properly.
.
The 8 programmes recorded have the same values:
610.105A
5 15