Operating Instructions - Kobalt SGY-CMI Mode D'emploi

ASSEMBLY INSTRUCTIONS
9. Assemble drum assembly (M) to motor (N) using
motor shaft pin (GG) and cotter pin (JJ).
BE SURE TO SECURE COTTER PIN PROPERLY
BEFORE MIXING ASSEMBLY IS IN MOTION.
HARDWARE USED
JJ 1
Cotter Pin
Motor Shaft Pin 1
GG

OPERATING INSTRUCTIONS

● Ensure to lock the retaining clip (Position 1) while transporting the mixer.
Unlock the retaining clip (Position 2) while dumping drum.
●
1. Before Using The Mixer
Ensure all bolts are tightened.
●
Position the mixer on a level surface.
●
NOTE: Maximum slope is 5 degrees.
Before filling the drum, make sure
●
the mixer can easily empty into a
wheelbarrow.
A "GROUND FAULT INTERRUPTER"
●
protected circuit is recommended for all
outdoor electric devices!
2. Transporting The Mixer
Slide retaining clip over handle to prevent
●
dumping. Always disconnect the power
prior to transporting the mixer.
Mixer can be transported in two ways.
●
Method 1:
a) Turn power to off ("O") position, disconnect
power cord.
b) Ensure drum is empty.
c) Facing front of mixer, grab handle and top
of drum. While holding right wheel down
with with your foot, pull mixer toward yourself.
Be careful not to tip mixer on yourself.
d) Move mixer to desired location.
LL
S1
O/I
13
Black
L
23
White
N
Green
PE
L1 Phase Wire
N Neutral Wire
PE Earth Wire
S1 Electromagnetic Switch
C1 Capacitor
METHOD 1
9
M1
14
Brown
Red
C1
Red
AA
24
Black
T1
A1
White
115Vac,60Hz,4.3A
T1 Thermal Motor Protector
M1 Motor
AA Motor Run Winding
AM Motor Start-up Winding
AM