Checking The Battery Level - ifrogz AIRTIME Manuel

AIRTIME Earbuds Instructions

Checking the Battery Level

Your case carries enough power for you to enjoy your wireless earbuds up to 4 times, for a total
of up to 15 hours. To check how much power it still carries:
1. Open the top of the case.
2. Press the battery button. The LED display will light according to how much battery remains:
a. The Battery Indicator inside the case will flash according to its current battery level. This
indicates your case is charging.
b. Wait for the Battery Indicator lights to turn off, indicating your case is fully charged.
c. Disconnect the charging cable and enjoy your new, portable power.
3. Recharge your case whenever you wish.
Troubleshooting
It's not likely you will have trouble connecting your buds, but due to interference with other
wireless signals, sometimes an extra step is needed.
Please follow these steps to reset the buds and sync them with your device:
1. When you open the case, the left earbud LED will flash indicating pairing mode. If the left
earbud does not flash for auto-pairing, a manual connection needed.
2. For a manual connection, take the earbuds from the case and hold both buttons for 5
seconds to turn them off.
3. After waiting a moment, press and hold the buttons for 7 seconds or until the white LEDs
begin to flash.
4. Next, place the buds back in the case and wait a moment. The buds are now synced to
each other and ready to pair with your device. Please reference the quick start guide for the
standard pairing procedure.
If you are still experiencing pairing issues, we suggest a full factory reset.
1. Finally, open your device's Bluetooth® settings and turn off the Bluetooth® feature. Wait a
moment, then turn it back on. Sometimes your device requires a restart. You can also restart
your device by shutting it down then powering it back on.