Basic Programming - Pentair SIATA V132-SFE Mode D'emploi

User Guide Siata V132-SFE
3.3. Description and components location
Long manifold
LCD display
DOWN button
UP button
Regen button
Twin pilots
3.4. Bypassing
If the system is equipped with a bypass and if a problem occurs, turn the valves to bypass the system as shown in the picture
below.
Out
4 . Programming
Note: 
The controller must be plugged to be programmed.
After 30 seconds without a button press, the unit returns to normal operation.
4.1.

Basic programming

Note: 
Menus are displayed in a defined and incremental order.
While the parameters are being edited, the
Display format change
A
Press to enter the menus sequence.
B
Adjust the format to be displayed with
C
Press to validate the selection and advance to the next parameter.
Time of day
D
Adjust the time with
→
Time flashes.
E
Press to validate the selection and advance to the next parameter.
Day of the week
F
Adjust the day with
→
Day flashes.
G
Press to validate the selection and advance to the next parameter.
6 / 36
Injector
Inlet (quick connection)
Outlet (quick connection)
Drain
Normal
operation
In
and
and .
and .
External pilot connections
Out
icon is on and blinking.
.
Short manifold
Injector
Inlet (threaded
connection)
Outlet
(threaded
Closed drain
connection)
In Bypass
In
Ref. MKT-UG-003 / C - 01.11.2019
Meter