Ricoh SP C360DNW Mode D'emploi page 10

Masquer les pouces Voir aussi pour SP C360DNW:

Table des Matières

Les langues disponibles

• It is dangerous to handle the power cord plug with wet hands. Doing so

could result in electric shock.

R CAUTION:

• Be sure to push the plug of the power cord fully into the wall outlet. Par-

tially inserted plugs create an unstable connection that can result in unsafe

buildup of heat.

• If this machine is not going to be used for several days or longer at a time,

disconnect its power cord from the wall outlet.

• When disconnecting the power cord from the wall outlet, always pull the

plug, not the cord. Pulling the cord can damage the power cord. Use of

damaged power cords could result in fire or electric shock.

• Be sure to disconnect the plug from the wall outlet and clean the prongs

and the area around the prongs at least once a year. Allowing dust to build

up on the plug constitutes a fire hazard.

• When performing maintenance on the machine, always disconnect the

power cord from the wall outlet.

Handling the Main Machine

R WARNING:

• Be sure to locate the machine as close as possible to a wall outlet. This will

allow easy disconnection of the power cord in the event of an emergency.

• If the machine emits smoke or odours, or if it behaves unusually, you must

turn off its power immediately. After turning off the power, be sure to dis-

connect the power cord plug from the wall outlet. Then contact your service

representative and report the problem. Do not use the machine. Doing so

could result in fire or electric shock.

• If metal objects, or water or other fluids fall inside this machine, you must

turn off its power immediately by first pressing the operation switch on the

control panel and then pressing the main power switch. After turning off the

power, be sure to disconnect the power cord plug from the wall outlet. Then

contact your sales or service representative and report the problem. Do not

use the machine. Doing so could result in fire or electric shock.

• When replacing the Fusing Unit, turn the main power switch off and wait at

least 30 minutes before proceeding with the replacement.

Table des Matières