Waeco MagicTouch MT2000 Instructions De Montage page 23

MT-2000.book Seite 23 Freitag, 12. Mai 2006 4:55 16
MagicTouch MT2000
7.2 Connecting to the vehicle indicators (cable set 2)
Note
Check the following:
– Whether the indicators are switched to postive (the cables to the
indicators carry +12 V when the indicators are activated).
– Or whether the indicators are connected to negative (the cables to the
indicators act as earth when the indicators are activated).
Depending on the type of switch, the position of the jumper (fig. 3 3
page 4) on the comfort indicator module has to be adjusted.
Key for the circuit diagrams for the connection to the vehicle indicators:
– Connection to a positively switched indicator: fig. 6, page 6
– Connection to a negatively switched indicator: fig. 7, page 7
No. in
fig. 6, page 6
Description
and
fig. 7, page 7
1 Comfort indicator module
2 Cable set 2 plug
3 Switched +12 V (ignition)
4 Indicator relay/indicator control unit
5 Indicator switch
6 Left indicator
7 Right indicator
8 Diodes
rt Red
or Orange
ge Yellow
gu Green
sw Black
➤
Insert the plug of cable set 2 into socket 2 on the comfort indicator module
(fig. 3 2, page 4).
➤
Connect the red cable to a switched power supply (terminal +15).
➤
Connect the green cable to wire between the indicator relay/control unit and the
indicator switch. A voltage impulse can be measured on this wire when indicat-
ing both left and right.
➤
Connect the orange cable to the left indicator wire.
Connecting the comfort indicator module
23