After Each Use - Power Fist 8957409 Manuel D'utilisateur

V4.0
STARTING THE HAMMER
To START the demolition hammer, press the 'I' on the switch.
To turn OFF the demolition hammer, press the 'O' on the switch.
For low temperatures, the demolition hammer reaches the full impact rate only
after a certain time. This start-up time can be shortened by striking the chisel in
the demolition hammer against the floor once.
SETTING THE IMPACT RATE
Select the impact rate with the 'speed adjuster function' knob according to the
material. The data in the following table are recommended values.
Speed Adjuster Function Knob 6
1
2
3
4
5
6

AFTER EACH USE

WARNING
•
Do not remove the chisel until it has cooled.
•
Store the hammer in a dry and clean place.
• Keep the hammer away from children.
MAINTENANCE
WARNING
•
Do not use solvents to clean the hammer.
•
Carbon brushes are consumable parts. When they become worn they can
cause problems with the motor. Use an auto-stop carbon brush which will
stop automatically when the carbon brush is worn, then replace the
brushes.
Visit www.princessauto.com for more information
120V 1,900 BPM SDS Demolition Hammer Kit
Impact frequency (min-1)
1000
1200
1350
1550
1750
1900
8957409
9