Wearing Style - Jabra WAVE Mode D'emploi

CONNECTIVITY
MobilSurf
BLUETOOTH
Infrared port
Wap options
Synchronization
Networks
SELECT
Manual pairing mode
If you wish to use the headset with a different phone, or if the pairing
process was interrupted, you can manually set the headset to
pairing mode .
Make sure the headset is on . Press and hold the answer/end button
for approximately 5 seconds until the Bluetooth® icon turns from
a steady light to a flashing light . then repeat steps 2 and 3 in the
above pairing guide .
Connecting with your phone
Pairing is only needed the first time a headset and phone are
used together . When the headset and phone have been paired
once, they will automatically connect when the headset is on and
Bluetooth® is activated on the phone . the headset can be used
when it is "connected" to the phone . If the devices are paired, but
do not immediately connect, tap the answer/end button . When
your headset is connected the Bluetooth® connection icon in the
statusDisplay™ will be constant on for 3 seconds and the headset
voice guidance will say "connected" .

WEARING STYLE

the Jabra WaVE follows Jabras popular behind the ear wearing
style . It can be worn on both ears simply by twisting the eargel .
Jabra WaVE comes with two different Jabra Comfort Eargels
fit any ear . You can also twist the eargel slightly to optimize the fit
and comfort .
For optimal performance, wear the Jabra WaVE and your mobile
phone on the same side of your body or within line of sight .
You will get better performance when there are no obstructions
between your headset and your mobile phone .
DEVICES FOUND
Jabra WAVE
SELECT
Jabra WaVE
Jabra WAVE
Passkey:
****
OK
HANDSFREE
Jabra WAVE
added.
The handsfree is
now ready for use
SELECT
to
tM
6