Remote Receiver; Remote Setup - Install/Replace Batteries; Replace The Remote Control Batteries; Replace The Remote Receiver Batteries - Empire Mantis BF28BMN-5 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Remote Receiver

The remote receiver operates on 4 AA-size 1.5V batteries.
It is recommended that ALKALINE batteries be used for maximum
battery life and performance.
The remote receiver has a 3-position slide switch for selecting the
MODE of operation: ON/REMOTE/OFF
With the switch in the ON position (toward the LEARN but-
ton), the fireplace will remain on until the switch is placed in
the OFF or REMOTE position, or until the burner switches are
turned off.
With the switch in the REMOTE position (centered), the fire-
place will operate commands received from the remote.
With the switch in the OFF position (away from the LEARN
button), the fireplace is off.
Note: It is suggested that the slide switch be placed in the off
position if you will be away from your home for an extended
period of time.
LEARN BUTTON
SLIDE SWITCH
OFF/REMOTE/ON
FREQUENCY
ADJUSTMENT
ACCESS HOLE

Remote Setup - Install/Replace Batteries

Both the handheld remote control and the remote receiver (located
inside of the fireplace) are battery operated. These batteries will
need to be replaced periodically as part of the normal mainte-
nance of the heater.
Page 8
S L I D
V E R
Y C O
T E R
B A T
BATTERY
COMPARTMENT

Replace the Remote Control Batteries

Slide open the battery compartment panel located on the back of
the remote control.
Remove the old batteries and install two AAA sized batteries into
the battery compartment.
Verify that the batteries are installed in the proper
Note:
position.
It is recommended that ALKALINE batteries be used for maximum
battery life and performance.

Replace the Remote Receiver Batteries

Remove the lower louvered panel of the fireplace and turn the
F F
N / O
Main power switch to the "OFF" position.
E S O
Lift the remote receiver from its location on top of the blower hous-
ing. The remote receiver is held onto the blower housing with hook
and loop tape.
Do not disconnect the wires.
Note:
BATTERY COMPARTMENT
RECEIVER LOCATION
ADJ.
LEARN
OFF
REMOTE
ON
30067-2-0315

Publicité

Table des Matières
loading

Table des Matières