Samsung HW-NW700 Manuel page 22

3. Connect the Wireless Receiver Module to the two Surround Speakers.
• The speaker cables are colour coded.
SURROUND-LEFT
4. Plug in the Wireless Receiver Module, and then check its standby status.
• The LINK LED indicator (blue LED) on the Wireless Receiver Module should blink. If the LED
does not blink, press the ID SET button on the back of the Wireless Receiver Module with a pen
tip for 5~6 seconds until the LINK LED indicator blinks (in Blue). For more about the LED, please
refer to the SWA-9000S user manual.
5. Press and hold the Up button on the remote control or press the ID SET button on the bottom
panel for at least 5 seconds.
• The ID SET message appears on the display of the Soundbar for a moment, and then disappears.
• The Soundbar will automatically power on when ID SET is complete.
SURROUND-LEFT
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3
L R
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3
ID SET
POWER
5 Sec
L R
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3
ID SET
L R
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3
POWER
ID SET
5 Sec
ID SET
POWER
ENG - 22
SURROUND-RIGHT
SURROUND-RIGHT
STANDBY
LINK
STANDBY
LINK
Blue
blinking
ID SET