Operating Instructions; Control Panel; Remote Control; Power Function - Style selections 2290FM-18-251 Mode D'emploi

OPERATING INSTRUCTIONS

Control Panel

Note: When the indicator lights are all on, there is no operation for 10 seconds, the machine enters the
blanking state, and the indicator lights are all off. Enter the blanking state. When any button is pressed again,
all the indicators will light up and display the state value or letter before blanking. If the button responds again
within 10 seconds, press the button to adjust the displayed corresponding function, 10 seconds blanking time
is reset.

Power Function

• Press the POWER ICON to turn the main power to the unit ON or OFF.
• The POWER ICON on the control panel and the remote control has the same highest priority
(compared to HEATER, FLAME).
• The POWER ICON has a memory function, its function is to memorize the current state (except
the timing function) and close all the functions that have been turned on. Press this button again to
restore the state set before turning off.
• If you use this key to turn off all the functions of the machine, you cannot turn on the machine by
pressing other keys.
• The digital tube displays the flame position by default when it is powered on: L4 high light.
Flame & Ember Bed Brightness Function
• Press the FLAME BRIGHTNESS ICON to adjust the flame and ember bed brightness at the same
time.
• Press the FLAME BRIGHTNESS ICON again to scroll down through the flame brightness settings:
L4-L3-L2-L1-OFF. In the OFF state, the flame ember bed goes out.
• The digital tube will display the corresponding value according to the user's setting, OFF does not
display.
• Brightness level: L4 (high light), L3 (medium light), L2 (low light), L1 (slightly light).
Heater Function
• Press HEATER ICON to turn on and off the heating function.
• When the HEATER is turned on and the temperature is displayed, press and hold the HEATER
ICON for 5 seconds to enter the temperature adjustment mode for temperature adjustment.
Note: This option is only available if using the control panel.
• Press and hold the POWER ICON for 5 seconds, the temperature unit will flash 3 times and then
you can switch between Fahrenheit and Celsius.
Note: This option is only available if using the control panel.

Remote Control

To use the remote control, first insert two
AAA batteries (included) into the remote
control. Ensure the polarities of the
batteries match the inside of the battery
compartment.
7
AAA 1.5V
AAA 1.5V