Cleaning And Maintenance - Young Living Dewdrop Mode D'emploi

Cleaning and Maintenance

Always turn off and unplug the diffuser prior to cleaning. To ensure proper
performance, clean the ultrasonic plate and lid after each use. If essential oil
begins to build up on the ultrasonic plate, gently wipe it off using a cotton
swab dipped in rubbing alcohol. If essential oil begins to build up on the
lid, gently wipe it off using mild soap and water only. Never use a corrosive
detergent to clean the ultrasonic plate or damage will occur. Periodically
check under the diffuser to keep the fan intake free of debris. Debris can be
removed by blowing on the fan intake opening or wiping with a clean, dry
cloth. (Do not use aerosol sprays, solvents, or abrasives to clean the plastic
housing.) When not in use, clean the diffuser and store dry. Replacement
ultrasonic plates can be purchased from Young Living.
Troubleshooting
When switched on, the diffuser does not operate.
• Check that the adaptor is securely plugged into the wall socket and the
rear of the diffuser. Check that water is in the reservoir and it is not above
the red water fill line marker. If there is too much water, unplug the unit
and adjust the water to the red water fill line marker and restart.
There is no mist or a lower amount of mist than usual.
• Unplug the unit before performing the following procedures. Check the
water level. If the water is above the red water fill line marker, carefully
pour out the excess water from the opposite side of the base ventilation
hole. Refill the diffuser water reservoir to the fill line and restart. Check
for essential oil buildup on the ultrasonic plate. If oil buildup is present,
8
!
Notice:
When emptying the
water reservoir, pour
water from the
opposite side of the
base ventilation hole.