Operation - Eskimo M43 43cc Mako Power Manuel De L'opérateur

OPERATION

1. The clutch will transfer maximum power after about two
hours of normal operation. During this break-in period
clutch slippage may occur. The clutch should be kept free
of oil or other moisture for efficient operation.
2. Drill holes without placing excessive body weight on the
unit. The auger operates most efficiently with a shaving ac-
tion caused by the weight of the unit itself.
IMPORTANT NOTE: The A-weighted emission sound pres-
sure level has been measured at 97 dB L
ed sound power level emitted has been measured at 107
dB L The total vibration value for Mako power ice auger
WA.
was measured at 45.7 m/s
3. Never run engine indoors. Exhaust fumes are deadly.
4. Do not use an ice auger in the earth.
5. The ice auger blade protector should be attached to the
auger blade when not in use. This will protect the cutting
edge of the ice auger blades.
6. To attach the auger to the powerhead, in the event this has
not been done, align hole at top of shaft with output shaft
hole. Insert bolt and secure bolt with provided allen wrench.
NOTE: The ends of the bolt should be flush with auger collar.
Bolt head and thread end should never go beyond ice collar.
USING THE SCREW-TYPE,
mANUAl vENTING GAS CAP
Your power ice auger is equipped with a screw type, manual
venting gas cap.
1. Before starting the engine, turn the screw in the top of the
gas cap all the way open (counterclockwise) to its venting
position. To ensure that gas will not spill during use, check
that the gas cap is screwed on tightly and the gas cap
screw is in the venting position.
2. After using the power ice auger and before putting away
or transporting it in a vehicle, screw the gas cap screw on
(clockwise) tightly. DO NOT OvER-TIGHTEN, AS THIS mAY
DAmAGE THE O-RING. This will prevent gas from leaking
during storage.
NOTE: When storing unit for prolonged periods of time in
warm weather, always vent gas cap to prevent gas from
leaking from carburetor.
6
The A-weight-
PA.
.
2
Check for parts online at www.geteskimo.com or call 800-345-6007 M-F 8-5 CST
WARNING
AvOID INjURY! mAkE SURE THE UNIT IS IN A STABlE
POSITION BEFORE PUllING THE STARTER HANDlE.
AvOID INjURY! WHEN THE UNIT STARTS TO FIRE
OR RUN, RElEASE
mOmENTARIlY WITH YOUR RIGHT HAND AND RETURN
YOUR lEFT HAND TO THE HANDlEBAR POSITION TO
mAINTAIN CONTROl AND STABIlITY OF THE UNIT
WITH BOTH HANDS.
CAUTION
AvOID INjURY! AlWAYS HANDlE FUEl IN A WEll
vENTIlATED AREA, OUTDOORS, AWAY FROm FlAmES
OR SPARkS.
AvOID INjURY! DO NOT START ENGINE IF FUEl IS
SPIllED. WIPE OFF ExCESS FUEl AND AllOW TO DRY.
REmOvE ENGINE FROm AREA TO AvOID SPARkS.
Operator's Manual
43cc Mako™ Power Ice Auger
THE THROTTlE CONTROl