INOVU PEV240 Instructions De Montage page 5

ELECTRIC SCREEN
SCREEN MOUNTING
Pieces provided:
Wall mounting Screen mounting
SCREEN SETTING
Every projection screen is supplied with pre-set limit switches to stop the surface in the up and down positions. If
necessary, these positions are adjustable. The holes on the left bottom side of the screen case give access to the
limit switches.
Adjustment of the DOWN position of the screen surface:
Remove plastic cap #1. Use an Allen key n°4 and
turn counter clockwise to lower the screen surface.
Attention: never roll down more than 10 cm extra screen surface.
Adjustment of the UP position of the screen surface:
Remove plastic cap #2. Use an Allen key n°4 and turn
counter clockwise to further roll up the screen surface.
Attention is required when adjusting the up position to prevent damage to the fabric.