Connection With The Indoor Component; Mounting The Outdoor Unit - Glen Dimplex MWMB 6 Instructions D'installation Et D'utilisation

Wandkonsole MWMB 6

3.3 Connection with the indoor component

Before positioning the outdoor unit, the refrigerant lines must
be mounted using the accompanying pipe set. This makes it
possible to route the refrigerant lines and electric wires so that
they are covered when the cover plate is mounted. Before sol-
dering, the two rubber grommets must be removed from the

3.4 Mounting the outdoor unit

With the rear wall removed, the outdoor unit must be posi-
tioned on the bracket at the front and pushed slowly towards
the wall. During this process, the refrigerant lines must be fed
Grommets must be
mounted prior to soldering
4x screws M12x35
4x washers Ø13
452169.66.01 · FD 0011
frame of the outdoor unit and placed on the pipe set. The screw
connections must be positioned on the markings in the bracket.
Otherwise, the connection takes place as described in the
chapter Mounting/connection in the main instructions.
into the designated grooves. The outdoor unit must be screwed
onto the bracket with the accompanying fixing material.
English
4x nuts M12
4x washers Ø13
EN-5