Important Safety Instructions - vds PHV Serie Manuel

IMPORTANT SAFETY INSTRUCTIONS

WARNING!
To reduce the risk of injury or death it is important to closely follow all of the following instructions.
Incorrect installation or inappropriate use may cause serious personal injury.
This installation manual and safety instructions are an integral part of the product and must be supplied to the user
.
These instructions should be retained by the owner and/or operator of the gate.
This product has been designed and constructed exclusively for the use indicated in this manual. Any inappropriate
use of this product may result in damage to the product and/or personal injury.
To ensure proper functioning of the product and personal safety only use the mounting equipment supplied and the
spare parts and accessories supplied by the manufacturer.
Do not install this equipment in an easily flammable environment. The presence of inflammable gases or smoke
are a serious threat to personal safety.
This equipment has an anti crushing safety device. In addition to this safety device it is also necessary to install
additional safety devices (for example: photo cells and/or pressure sensitive strips, etc.) that will prevent any
danger resulting from mechanical movement (for example crushing, pulling or ripping).
In addition to the above mentioned safety devices it is also necessary to install at least one light signal as well as a
printed notice fixed to the gate.
The installation of this equipment, the electrical connections and maintenance of the equipment may only be
carried out by qualified technicians.
Failure to meet this requirement may cause severe injury and/or death, for which
the manufacturer will not be held responsible.
For protection against electrical overload or short circuit, always install a 0.03 amp differential and a thermal
magnetic switch with a contact aperture of at least 3mm
This equipment must be earthed with a yellow/ green cable, connected to the earth terminal in the junction box.
The safety of this product is only guaranteed if the equipment is properly earthed.
Before operating this product you must ensure that all connections have been properly made, that the safety
devices are properly working and that the pressure force is adjusted to the minimum according to regulations
regarding automatic doors (EU Directive 89/392 and EN 12453 y EN 12445 norms).
Before installing this equipment, ensure that the structure of the gate is strong enough and properly balanced. The
gates
must work freely in both directions and have no friction points before the automatic operator is installed.
SAFETY INSTRUCTIONS FOR THE USER
In the event that a malfunction in the equipment, contact a qualified technician. DO NOT try to repair the equipment
yourself.
Do not allow children or pets near the gate. Never allow children to play with the gate controls. Keep the remote
control in a safe place, out of reach of children and unauthorised persons.
In the event of a power cut or emergency,
you must learn how to use the manual release mechanism according to the
procedures found in this installation manual
Keep these safety instructions in a safe place. Make sure that all persons who use the gates or who may be near
the gates when they operate are aware of the dangers associated with automatic opening gates
If you sell or rent the property with this equipment installed, give the new owner or tenant a copy of these safety
instructions
Ed1. 14/12/09 (English)
2 of 10