Operating Temperature - Garmin ecoRoute HD Mode D'emploi

Customizing the Cable angle
If the vehicle requires the cable to be at an angle from
the connector, you can use the cable ties to customize the
cable for the installation.
1. To better suit some installations, bend the cable around
the connector.
2. Use a cable tie to secure the cable.
Wirelessly Connecting with a Garmin
GPS Device
Before wirelessly connecting with a GPS device, you must
update the GPS device software and install the ecoRoute
HD device.
1. Start the vehicle, but remain in park (stationary).
The LED blinks three times every two seconds. The
ecoRoute HD device is waiting to connect with the
GPS device.
2. Turn on the GPS device.
3. Bring the GPS device within 10 meters (33 feet) of the
ecoRoute HD device.
4. From the Tools menu, touch ecoRoute.
5. If necessary, follow the on-screen instructions to set up
ecoRoute.
6. From the ecoRoute menu, touch HD Connection.
7. Follow the on-screen instructions to connect the
ecoRoute HD device with the GPS device.
The LED turns blue when the ecoRoute HD device is
connected to your GPS device.
8. Turn the vehicle off and then back on to save the setup
information.
After the initial connection, the ecoRoute HD device will
automatically connect to the GPS device when they are
turned on and are within 10 meters (33 feet) of each other.
Note: When the ecoRoute HD is not connected with a
GPS device, the ecoRoute HD device records the vehicle
information and sends the data to the GPS device the next
time they connect.
about the LEDs
The two LEDs, green and blue, on the top of the ecoRoute
HD device indicate the connection status.
LED Meaning
Three flashes Establishing a connection with vehicle
and GPS device. Setup mode.
Green flashing Connecting to the vehicle.
Green solid Communicating with the vehicle.
Blue flashing Connecting to the GPS device.
Blue solid Communicating with the GPS device.
Two flashes Update mode.
Viewing ecoRoute HD Data
If, at any time while using the ecoRoute HD device, you
become concerned about your vehicle's operation, pull
over, off the roadway, in a safe and legal manner. Remove
the ecoRoute HD device from the OBD II connector.
On your GPS device, touch tools > ecoRoute.
For more information about using your Garmin GPS
device with ecoRoute HD data, refer to the ecoRoute HD
Supplement at www.garmin.com.

Operating temperature

From 5°F to 158°F (from -15°C to 70°C).
Resetting the ecoRoute Device
Reset the ecoRoute device if it stops functioning.
Press and release the ReSet key to reset the device.
•
• Press and hold the ReSet key for 3 seconds to restore
the factory settings.
Note: When restoring the factory settings, the
wireless connection information and recorded vehicle
information is deleted.

Notice