Hisense BBCD-535WY Manuel D'instructions Utilisateur page 11

11
Open the water valve to flush the
lines, and check leakage in the water
connectors. If any leak, please check
that if the lines are fully inserted
where the connector leaked. If not,
please install them again, and make
sure that the lines are fully inserted.
Note:
After connect the filter outlet line
with the refrigerator(as shown in the
diagram below), please dispense
several cups of water to flush the lines
before use.
The water lines should not be
pressed by heavy things and should
not bend too much.
Warning!
After turning on the water valve,
make sure that there is no leakage at
all connection points of the water
lines. If there is a leakage, turn off the
valve immediately and tighten the
water connector or make the lines
fully inserted into the connector.