Troubleshooting - Zephyr PRW24C02BG Guide D'utilisation, D'entretien Et D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Troubleshooting

POSSIBLE
PROBLEM
The
appliance
does not
operate.
The
appliance is
not cold
enough.
Turns on and
off
frequently.
POSSIBLE CAUSE
Not plugged in.
The appliance is turned off.
The circuit breaker tripped
or a blown fuse.
Sabbath mode may be
enabled.
Check the temperature
control setting.
External environment may
require a higher setting.
Demonstration mode may
be enabled.
The door is opened too
frequently or for long
periods of time.
The door gasket does not
seal properly.
The cooler does not have
sufficient ventilation.
The cooler has restricted
air flow due to too much
storage.
The room temperature is
hotter than normal.
The door gasket is not
sealing properly.
The door is open too often.
The cooler does not have
the suggested ventilation.
The door is not closed
completely.
Ensure the appliance is
plugged in and the power
outlet has power.
Turn on the appliance.
Replace the broken fuse or
reset the breaker.
See Operation page and verify
Sabbath mode is disabled.
Adjust the set temperature.
Keep the appliance away from
sunshine or other heat sources
See Operation page and verify
Demonstration mode is
disabled.
Close the door tightly and do
not open the door too
frequently or for a long period
of time.
Ensure the door gasket is not
loose.
Read and follow the
"installation clearance
requirements" section.
Open space in the cabinet to
allow air flow.
Run the refrigerator at the
appropriate ambient
temperature.
Make sure the door gasket is
properly sealed.
Minimize the number of times
the door is opened.
Read and follow the
'installation clearance
requirements" section.
Make sure the door is
completely closed.
20
SOLUTIONS

Publicité

Chapitres

Table des Matières
loading

Table des Matières