Jimmy F6 Manuel De L'utilisateur page 8

Please stop using the machine If you see the fire in the
outlet during hot wind mode, clean the dust in the inlet and
outlet, otherwise it might cause scald or fire.
Please keep the distance of more than 10cm between hair
and inlet,avoiding hair from entangling into the hair dryer.
Please keep the distance of more than 3cm between hair
and outlet to avoid scald.
The product is only for the use of drying hair, please do not
use to dry shoes or clothes etc., otherwise it will cause
electric shock or fire due to short circuit.
The hair dryer is equipped with overheating protection
system, the power will be cut when it is over-heated.And
switch off and unplug immediately, let it cool down for a
minutes. Check if there is some fluff or hair in the inlet or
outlet, then switch on again.
When the hair dryer is used in the bathroom, unplug it after
using, even though the hair dryer is powered off, it is still
dangerous when it is close to water.
For the purpose of protection, it is recommended to install
30mA RCD, please ask local RCD installation agent for
detail information.
Please do not use hair dryer next to bath tub, shower,
lavatory or other utensil etc..
The appliance is equipped with heating surface, for the
people who are not sensitive to the heat (like diabetic) use
it with the help of normal people.
Please make sure to adjust to "off" after using, unplug the
socket, otherwise it might cause scald or fire.
If the power line is damaged, which must be replaced by
professional staff from local agents.
Note: This sign means Forbidden to use it during bath or
shower.
12
Trouble Shooting
Please check the following issues before
sending to designated repair offices.
Failure 1:The motor is not working.
Possible Cause 1:Not plug in tightly
Solution 1:Check whether it plug in tightly
Possible Cause 2:No power on the socket
Solution 2:Check the socket
Possible Cause 3:The switch On is not in proper position
Solution 3:Switch on to the proper position
Failure 2:Press On,not working
Possible Cause:The button has been pressed too quickly,
machine protection has been started
Solution:Press "off", wait 2-3 seconds, then start again
Failure 3：Power off suddenly
Possible Cause 1:Overheating protection system started
Solution 1:Switch off and unplug the power line, reuse it
after it cool down for a minutes
Possible Cause 2:The inlet was blocked by fluff, hair etc.,
which lead to overheating protection system
Solution 2:Switch off and unplug the power line, reuse it
after it cool down for a minutes
Failure 4:Air volume is small
Possible Cause:The inlet was blocked by fluff, hair etc.,
Solution:Clean outlet
13