Publicité
IPD-SM5 Series
Important Safety Instructions
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings. Install in accordance with the
manufacturer's instructions.
Consignes de sécurité importantes
1) Lisez ces instructions.
2) Conservez ces instructions.
3) Respectez tous les avertissements.
4) Suivez toutes les instructions.
5) Ne pas utiliser cet appareil près de l'eau.
6) Nettoyer seulement avec un chiffon sec.
7) Ne pas bloquer les ouvertures de ventilation. Installer conformément aux
instructions du fabricant.
1. Unpack speaker and mounting
hardware.
2.
5. Line up bracket ribs with
mounting tube slots and press
speaker onto bracket. Twist
clockwise until speaker clicks.
Speaker is now locked in place.
Installation instructions for:
IPD-SM500i-II
2. Choose a secure mounting
surface with suf cient strength to
reliably hold the speaker. Note:
Bracket orientation does not
matter for installation of the
mounting bracket.
1.
1.
6. Firmly grip speaker and pull it
away from the wall to rotate to
desired mounting angle about the
mounting shaft axis. Simply
release speaker back toward the
wall to lock into place.
8) Do not install near any heat sources such as radiators, heat registers, stoves, or
other apparatus (including ampli ers) that produce heat.
9) Only use the attachments/accessories speci ed by the manufacturer.
10) Unplug this apparatus during lightning storms or when unused for long periods
of time.
11) Refer all servicing to quali ed service personnel. Servicing is required when the
apparatus has been damaged in any way, such as power-supply cord or plug is
damaged, the apparatus has been exposed to rain or moisture, does not operate
normally, or has been dropped.
8) Ne pas installer près de sources de chaleur telles que des radiateurs, registres de
chaleur, poêles ou autres appareils (incluant les ampli cateurs) qui produisent de la
chaleur.
9) Utiliser uniquement les xations / accessoires spéci és par le fabricant.
10) Débranchez cet appareil pendant les orages ou si inutilisé pendant de longues
périodes de temps.
11) Con ez toute réparation à un personnel quali é. Une réparation est nécessaire
lorsque l'appareil a été endommagé de quelque façon que ce cordon d'alimentation
ou la che est endommagé, l'appareil a été exposé à la pluie ou à l'humidité, s'il ne
fonctionne pas normalement ou s'il est tombé.
3. Plug ethernet cable into RJ45
jack. If local power is required at
speaker (non-POE installation),
connect appropriate DC power
supply to barrel connector on
speaker input panel. Contact
SoundTube for questions about
installations requiring local power.
2.
7. Make sure knob is loose, and
aim speaker in desired direction (0
to 90). Tighten the knob to lock
the speaker in place. FINGER
TIGHT IS SUFFICIENT-DO NOT
OVER TIGHTEN.
To loosen, use included hex key.
|
1.913.663.5600
855. 663.5600
4. Use supplied safety screw to
connect the safety cable to one of
the inserts on the rear panel of the
speaker. Connect other end of the
safety cable to a secure mounting
point.
8. Done.
|
www.soundtube.com
Publicité
