Table des Matières
Publicité
The submenus available are the same ones available with the bidirectional connection, thus:
-
The three buttons located alongside the display allow you to edit the new broadcast processing curve: select
the curve from among the 40 available, using the two arrows, then confirm the choice using the rectangular
button in the middle.
The Edit submenu contains all of the parameters and operations regarding setting a new processing curve.
Note that in this case it is NOT possible to use the Get Preset function to call up one of the existing curves,
but simply to set the various parameters of a new curve (compressor threshold levels, Density and
Brilliance levels, level and type of Super bass). Once this curve has been set, it must be saved in one of the
10 locations set aside for the user (through the 'Save As' window at the lower left of the Edit screen), then
the command sent to the processor ('Save' button in the lower right): the processor will automatically start
using the new curve.
-
The Output submenu includes the controls for the functions: Output Level, Pre-emphasis, Noise Gate,
Output Mode.
-
The Input submenu includes the controls for the functions: AGC Mode, AGC Speed and AGC Level
-
The MPX submenu includes the controls for the functions: Pilot Phase and Pilot Level
-
The PlugIn submenu includes the controls for the optional functions available: RDS Level and Phase,
Stereo Enhancer Effect Level - Effect Band and Effect Depth, Digital Input On or Off.
-
The RDS submenu includes the programming windows for the RDS functions
NOTE: In each menu, any changes to the parameters may be saved by clicking the 'Send' button, while clicking
'Cancel' allows you to abandon the changes (or the submenu) without saving.
Those parameter values that fall outside the recommended range are signaled by a bright red color, and by the
'Warning' lamp on the front panel of the processor. In addition, selecting external Pre-emphasis and digital input
will cause the corresponding LED to light on the processor panel.
Note that, while receiving a relevant data packet
Remote PC Host in Control.
LOGICIEL DE COMMANDE SUR PC
,
the processor display momentarily shows the message
F R A
Page 48
Publicité
Table des Matières
