Control Instructions For Use; Switching The Control On; Elements Setting; Using The Low Power Scale - Verona VECTIM365 Manuel D'utilisation Et D'entretien

CONTROL INSTRUCTIONS FOR USE

This touch control works using optical light sensing
technology. When first connecting electrically or
after a power failure, any direct strong light over the
sensor area may affect the touch control functionality.
When powering on the unit make sure that no strong
light is shining direct over the touch control zone,
it can compromise the start-up sensor calibration
resulting in an unresponsive touch control.
When the cooktop is connected to the electrical voltage
supply all lights and digits turn on to indicate a proper
activation. This operation will be completed after few
seconds, the control turns off automatically. Now the
cooktop is ready for operations.

Switching the control on

Eventually hold the [LOCK] key in case the commands
are locked (see that the lock led is on and turns off after
a few seconds).
Touch the main [ON/OFF] key in order to make each
single zone available for selection.
All the displays show power level "0", if no actions are
performed the control shuts down again after about 10
seconds.

Elements setting

Touch the proper [ON] key (ref.2) in order to select the
desired zone: the HOT SURFACE (ref.3) indication
starts flashing, waiting for a user input.
2
Figure. 6
Touch the slide bar to set the power level (levels 0 to
9 are available), moving the finger along it or directly
touching the desired value.
10
WARNING
5a
4
1
3
The display (ref.4) and the "Peacock Tail" (ref.6) show
the power level, updated in real time.
After a 5 seconds time-out the value is accepted, the
HOT SURFACE led (ref.3) stops flashing and gets
steady. The "Peacock Tail" disappears after some
seconds more.
Touch [ON] key to confirm the value before the time-out
expires.
The following picture represents the Full Power Scale
whereas the control uses all the available power range,
from 0% up to the 100% corresponding to level 9.
Level 4 corresponds to 15% of the available power.
6
7
Figure. 7

Using the Low Power Scale

Once a cooking zone has been selected, touch the
[LOW TEMP] key (ref.8) in order to enable the Low
Power Scale (ref.9) then set the power level in the
usual way.
8
Figure. 8
Use & Care Manual
ENGLISH
9