Three Ways Of Recharging; On Mains Power Or Via A Generator; On A Car Cigarette Lighter - TecSup BABY Manuel D'utilisation

BABY

5 / THREE WAYS OF RECHARGING

5.1 On mains power or via a generator

Plug-in the mains power cable (found inside the case) and connect to
"secteur/mains" socket. The wide range of input voltages allows this
product to be charged on any monophase current, anywhere around
the world. Use an interface if needed or buy a specific mains cord to
your local country.
Once the charge is finish, unplug and make sure the protective
waterproof caps are screwed onto the sockets.
The charging time depends on the temperature inside the BABY. To
optimize the reliability of electronics, a derating of the charging will
operate according to the internal temperature. To optimize charging,
TECSUP recommends opening the lid for a quick recharge.

5.2 On a car cigarette lighter

Plug-in the cigarette lighter cable (found inside the case) and connect to
the "entrée 12VDC". Your vehicle cigarette lighter must be protected by
a 6A fuse minimum; the majority of car cigarette lighters are protected
by a 10A fuse, so this point should not be a problem.
Once the charge is finished, unplug and make sure the protective
waterproof caps are screwed onto the sockets. Replace the cables
inside the case.
In the event that you don't need to use your BABY Led Light for long
periods (months), we advise you to keep the light plugged into the
mains or your cigarette lighter indefinitely. This will ensure that the
batteries are always fully charged and ready for use.
TECSUP – BABY – Users manual - 80300106 J – P 21 / 41