Symbols On The Unit; Symbols On The Charger; General Safety Regulations - IKRA APS 2010 LI Manuel D'utilisation

SyMBoLS on tHe unIt

Caution!
read the operating instructions.
Do not use the equipment in the rain or
in a wet environment.
Danger of injury from cuts.
Wear cutproof gloves.
Danger of eye injuries!
Wear safety goggles!
Do not place electrical equipment or
batteries in domestic waste.
Caution! The saw blade continues to
run. Wait until it comes to a standstill.
Keep hands away!

GenerAL SAfety reGuLAtIonS

This machine is not intended for use by persons (includ-
ing children) with an impaired physical, sensory or mental
capacity or insufficient experience and/or insufficient
knowledge unless they are supervised by a person
responsible for their safety or receive instructions from
that person in the use of the machine. Children should
be supervised in order to ensure that they do not play
with the machine.
remain alert, pay attention to what you are doing and
proceed sensibly when working with an electric tool. Do
not use the machine if you are tired or under the influ-
ence of drugs, alcohol or medication.
General safety information for power tools
Warning! read all safety-related information
and safety instructions! Failure to observe the
safety information and instructions may result in
electric shock, burns and/or severe injury.
Keep the safety information and instructions for
future reference.
The term 'power tool' as used in the safety information
and instructions includes both mains-operated tools
(with power cord) and battery-operated tools (without
power cord).
1) Safety at the workplace
a) Keep your working area clean, tidy and well-lit.
Disorder and poorly lit working areas may result in
accidents.
GB | Operating Instruction

SyMBoLS on tHe CHArGer

SyMBoLeS In tHe MAnuAL
b) Do not operate the power tool in potentially
c) Keep children and other persons away while you
2) electrical safety
a) the mains plug of the power tool must fit into the
b) Avoid physical contact with earthed surfaces as
c) Keep the tool out of the rain or moisture in
d) Do not use the cord to carry or hang up the tool
e) When operating a power tool outdoors, use ex-
GB-3
protection class II
protective temperature limiter
pole orientation
safety transformer
Before using for the first time, carefully
read through the user manual.
The recharger is for indoor use only.
machines do not belong with domestic
waste.
Caution! Warning symbols with
information on damage and injury
prevention.
explosive environments containing combustible
fluids, gases or dusts. Power tools generate sparks
that may ignite dusts or fumes.
are operating the power tool. Distractions may re-
sult in the operator loosing control over the tool.
mains socket. the plug must not be modified in
any way. Do not use adapter plugs/connectors in
combination with tools with protective earthing.
Unmodified plugs and fitting sockets reduce the risk
of electric shock.
pipes, heaters, ovens and refrigerators. There is
an increased risk of electric shock if your body is
earthed.
general. The penetration of water into a power tool
increases the risk of electric shock.
or to pull the plug out of the socket. Keep the
cord away from heat, oil and sharp edges or
moving parts of the tool. Damaged or tangled cords
increase the risk of electric shock.
clusively extension cords that are approved for
outdoor-use. The use of an extension cord that is
suitable for outdoor use reduces the risk of electric
shock.