Elta GWK-2200.3T Manuel D'instructions page 12

3, Instructions of button:
1) " " key :
Press the start button to start heating, press it again to stop heating,
Followed by Recycling. Default 100 degree heating
2) " "key:
Select the temperature, press the "
preservation mode
3) " " key:
Temperature selection button,
4. Instructions of LED on the kettle body:
1) Pre-set temperature is 50℃ -- the LED shine green;
70℃--the LED shine blue; 80℃--the LED shine purple ,
90℃--LED shine yellow; 100 ℃--LED shine red;
2) The LED turns on in the process of set temperature, heating or keep warm:
When finish heating the LED turn off;
5. Instructions of Working Status:
Normal mode:
1) Power on → Buzz twice → Indicator light all light up 1 second → LED
on kettle body flash, green, blue , purple ,yellow, red in turn → into standby
status
2) After power on, default pre-set temperature is 100℃, Press start button to
boiling directly, when water temperature get 98℃, kettle start timing and stop
heating after 8-10 seconds, then turn into standby status after buzz twice.
3)If not press start button after pre-set temperature, the corresponding
indicator light shall turn off after 15 seconds, and kettle turn into standby status.
4) when start heating after pre-set temperature, the indicator light turn on,
after water get pre-set temperature kettle stop heating, then buzz twice, the
LED on kettle body turn off, the .Boiling water temperature range is + 3
degrees;
Keep warm mode:
1) Select the temperature, press the "
preservation mode
2) In keep warm mode, when the water temperature get pre-set temperature
first time, kettle shall buzz twice, and will not buzz afterwards
3) After get pre-set temperature first time, kettle start keep warm in 30 minutes,
when water temperature below pre-set temperature, kettle start heating
" key and " " key to enter the heat
" key and " " key to enter the heat