sunjoe TRJ13STE Manuel D'utilisation page 14

Troubleshooting
Problems Possible Cause
The motor does not
run or the tool runs
slowly.
Auto line feed does
not work.
Line fails to cut off.
• Power failure/unit not plugged
into a working receptacle.
• Spool housing cannot rotate freely.
• Cutting line does not protrude.
• Trimming blade bound with
accumulated grass.
• Auto feed out of line.
• Spool bound up.
• Auto feed is dirty.
• Spool line twisted when refilled.
• Not enough line is exposed.
• Line cutter in guard is covered,
damaged, or missing.
• Line extends past guard.
Possible Solution
• Check to make sure the unit is plugged into a working
outlet. Make sure the extension cord is not damaged.
• Remove the spool and clean the slots; carefully remove
any grass and weeds or other debris.
• Cut the spool line off so that it just reaches the line
trimming blade.
• Take the trimmer to an authorized service center if the
trimmer does not start after completing these checks.
• Stop the machine and clean the trimming blade.
• Install a new spool of cutting line.
• Clean the auto feed.
• Remove the spool cover and pull the cutting line until it
reaches the trimming blade.
• Contact your authorized Snow Joe
or call Snow Joe + Sun Joe
®
1-866-SNOWJOE (1-866-766-9563).
• Rewind or trim line to line cutter.
14
+ Sun Joe dealer
® ®
customer service center at
®