DOREL Living DA7967-1 Mode D'emploi page 12

TWIN OVER TWIN UPHOLSTERED BUNK BED
DA7967-1 / DA7967-2
STEP 6
Insert slat (L) into remaining holes on the bottom side rails (I and K) on the lower bunk.
Secure salts (L) to the bottom side rails (I and K) with flat head wood screws (4) using a
phillips head screw driver (not included).
Repeat step 5 and 6 to attach slats (S and L) to the upper bunk.
NOTE:Slats (S and L) will be placed between two wooden blocks.
NOTE: If you notice that any slats (L) are not perfectly flat, be sure to assemble them so
that slats (L) curves up in the middle and down on the ends.