Variable Installation Possibilities: Overlying Installation; Variable Installation Possibilities: Flush Installation - KÜPPERBUSCH KI9850.0 Mode D'emploi

7.4 Variable installation possibilities: Overlying
installation
Dimensions in mm
4
4
50
1
Minimum distance to adjacent walls
Opening dimensions
Cutout dimensions
Outer dimensions of the hob
Important:
There is a risk of breakage if the hob is canted or sub-
jected to stress during installation!
34
Instructions for assembly
4
898
750 50
2
1
7.5 Variable installation possibilities: Flush in-
stallation
Dimensions in mm
2
3
3
50
1
Minimum distance to adjacent walls
Opening dimensions
Cutout dimensions
Outer dimensions of the hob
Glue the sealing tape onto the corner of the supporting
edge of the worktop so that no silicone adhesive can be
pressed under the hob.
Place the hob into the worktop cut-out without any adhe-
sive and align it. Use shims if necessary
Fill the gap between the hob and the worktop with heat-re-
sistant silicone adhesive.
Important
Silicone adhesive must not get under the support sur-
face. If this occurs it will not be possible to remove the
hob again at a later stage. No liability will be assumed
in the case of failure to observe these instructions.
3
902
+2
750 50
2 1
GB
2