Care Instructions; Your Product; Precautions For Use - Hesperide BAYANA 149492 Mode D'emploi

CARE INSTRUCTIONS

1/ Your product

Properties
Epoxy steel is a steel covered with a protective paint against rust.
Resin wicker PE (polyethylene) is a recyclable plastic material (polyethylene.) Its braiding is done
by hand.
Manufacturing and assembly
The manufacturing then assembly of this product requires leaving clearance between the different
parts.
It is therefore normal to observe gaps/slack that may reach several millimetres between the different
assembled elements (between two slats, between boards...).
This tolerance necessary for the correct realisation of your product can be behind little geometric
differences.
This does not lead to any loss of function of your product.
Irregular appearance
Each product is manufactured and assembled industrially from parts whose surface treatment is
carried out individually, before assembly. These metallic elements cannot be free from appearance
irregularities coming both from the surface treatment process and assembly operations. The final
appearance of the product is therefore directly linked to these possible irregularities.
Regularity of the braiding
This garden furniture is entirely hand braided. The braiding technique consists in an intertwining of
synthetic resin strands around a metallic structure. It is possible to observe braiding tension
differences. At each break point, the end of the strand in addition, ranging up to a few centimetres,
is inserted into the braiding. If this strand comes out, put it back in place. There is no risk of the
braiding becoming undone.
Synthetic resin imitates natural rattan. Rattan has appearance irregularities that give it its unique
character. The manufacturing process reproduces these variations in look and shade.

2/ Precautions for use

Watch out for blows from knives and other sharp objects handled nearby. Watch out too for burns
from cigarettes and from other heat sources.
3/ Maintenance and ageing, siding
It is normal to note natural wear and tear of the product over time and with use, in the form of an
alteration of the colours and the state of the surface, the mechanical functions and tightening of the
screwed elements.
Exposure to UV rays
Over time, you can see a discoloration of the materials exposed to UV rays (textiles, paint, plastics),
a phenomenon also due to the rays of the sun as well as those of the moon. This evolution of colours
exposed to external elements is normal and concerns in particular bright colours.
Everyday maintenance
Your product is subject to external elements, it must therefore be regularly cleaned.
Remove stains immediately.
Clean with a damp cloth soaked in warm soapy water (or hot water for more marked dirt) or a
specific, adapted product.
Rinse thoroughly.
Finish with a clean, dry cloth.
If in doubt, consult a reseller or the material sheet on the Hesperide.com website.