Care Instructions; Your Product; Precautions For Use - Hesperide BARCELONE 159602 Mode D'emploi

CARE INSTRUCTIONS

1/ Your product

Properties
Aluminium is a light, resistant material that doesn't rust.
Polyester is a synthetic fabric that offers good resistance to tearing and rubbing.
Cord or acrylic knit is made up of a mix of polyester and polyamide fibres, around an EVA (ethylene-vinyl ac
etate) core, which gives it both flexibility and rigidity. It is hand braided.
High pressure laminate (HPL) is a material made up of sheets of paper impregnated with thermohardening r
esin and an upper layer in decorative melamine resin.
The different layers are aggregated under the combined effect of heat and pressure thus giving a product ad
apted to outdoor use. The high pressure laminate (HPL) is a material with a smooth, non-porous surface, ea
sy to clean.
Manufacturing and assembly
The manufacturing then assembly of this product requires leaving clearance between the different parts.
It is therefore normal to observe gaps/slack that may reach several millimetres between the different assem
bled elements (between two slats, between boards...).
This tolerance necessary for the correct realisation of your product can be behind little geometric differences.
This does not lead to any loss of function of your product.
Irregular appearance
Each product is manufactured and assembled industrially from parts whose surface treatment is carried out
individually, before assembly. These metallic elements cannot be free from appearance irregularities coming
both from the surface treatment process and assembly operations. The final appearance of the product is the
refore directly linked to these possible irregularities.
Regularity of seams
Although we pay special attention to the quality and regularity of seams, it is possible to notice that some thr
eads are not cut after the break point of the seam. There is no risk of the seam becoming undone. Cut this th
read with a simple pair of scissors.

2/ Precautions for use

Do not put hot objects on the table itself, they will leave permanent marks on it (discoloration, deformation, cr
acks...). Always use table mats.
Do not use a plastic tablecloth on the table. Exposed to UV and heat, it would melt and act as a decal, espec
ially on steel, aluminum and glass. This would result in irreparable deterioration of the tray in the form of whit
e streaks. Instead, use a fabric tablecloth.
Watch out for blows from knives and other sharp objects handled nearby. Watch out too for burns from cigar
ettes and from other heat sources.
If you don't use your cushions for a long period, it is advised to put them away to avoid possible discolourati
on during too long an exposure to UV rays.
3/ Maintenance and ageing, siding
It is normal to note natural wear and tear of the product over time and with use, in the form of an alteration of
the colours and the state of the surface, the mechanical functions and tightening of the screwed elements.
Tightening
The assembly parts of your product become loose over time. Think of tightening them regularly.