Siding Tools Industries UK-12 Manuel D'utilisation page 7

MAINTENACE
Block change according to the material
to be cut
Clear the block completely. Hold
or attach the blade holder to
secure it in the raised position.
Remove the blocks. Position
another block according to the
material to cut. Screw the 4
screws lightly.
Warning: Do not put your fingers
against the sharp edge of the
blade at any time.
Block change according to the material
to be cut
Lower the blade to the cutting
position to validate the alignment
of the block. Tighten the 4 block
fixing screws.
Warning: Do not put your fingers
against the sharp edge of the
blade at any time.
Block change according to the material
to be cut
Re-engage the pivot pin.
Warning: Perform a cut test
before proceeding to validate the
alignment of the blade with the
block.
-6-