Quantum TURBO SC Slim Compact Guide Rapide D'utilisation page 6

TSC INSTRUC trans 8/8/06
6. FLASH INDICATORS
A yellow flash indicator [
A steady light means the output is supplying flash or camera
power.
A Blinking indicator shows when high voltage has shut down.
Off indicates no power for that output.
7. ERROR CONDITIONS and TROUBLESHOOTING
Symptom
A Flash Cable is connected
but the output indicator is
not lit.
A Flash Cable is connected
to a flash and the output
light blinks for 30 seconds.
The fuel gauge's 25%
green light blinks for a few
minutes, and then all lights
go out and there is no power
to the equipment connected.
8. WEARING TURBO SC
Turbo SC may be clipped onto a belt with its
attached belt clip.
The Turbo SC also can be worn over a shoulder
using the shoulder strap. For comfort, the belt clip
may be removed from Turbo SC, as shown in the
diagram.
Loosen the screws a few turns and remove the
belt clip. Do not remove the screws completely!
Re-tighten the screws with moderate pressure.
8:28 PM Page 6
] shows the status of flash power.
Solution
The cable could be broken, shorted, or
it may be the wrong cable.
Turbo SC has detected that no flash is
connected. This could be caused by
an intermittent or broken cable, or a
cable that is not fully engaged in the
socket.
This is the low battery indication.
Recharge. Check that the charger is
connected to a live mains outlet that
cannot be switched off.
4