Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY
− Loosen and remove the rod fixing ring nut from the top of the lower tube. Slide the
decorative cap from the base onto the tube. Replace and tighten the rod fixing ring.
− Then connect the tube assembly to the round base
counterweight. From underneath, insert the washer and tighten the assembly using the
supplied angle screw. Squeeze until it is properly locked.
− Slide the base decorative cap down over the assembly.
− Remove the lock nut from motor shaft. (anticlockwise)
− Place the rear grill on the motor housing, making sure to position the housing lugs in the
guide holes of the grille.
− Firmly tighten (clockwise) the locknut to secure the rear grille.
− Place the fan blade on the motor shaft by placing the notches in the blade in the shaft
passing through the motor shaft.
− Tighten with the reverse nut (counterclockwise and lock the blade securely).
− Place the front grille and install the plastic strapping ring around the grilles to hold them.
Be sure to position the edges of the 2 grids in the 2 notches inside the strapping.
− Tighten the grid screw to secure the ring.
− Insert the inner tube in the main body
(control panel) of the fan and fix it with
the screw at the back.
positioned on the
and
EN-7
Publicité
